Exported pipe bending machineused seamless steel tubes, welded steel pipe or spiral steel pipe as raw material, intermediate frequency heating, its power and frequency can be adjusted to ensure the appropriate diathermy depth, to ensure the stability of steel tube material properties, intermediate frequency power factor above 0.95 , save energy, new design, compact structure, automation and production efficiency.
Range of pipe bent OD.57mm-1620mm(2inch to 64inch) Range of pipe thickness: 5-100mm Range of bending radius:2.5D-6D Range of bending degree:0-180 degrees
Exported pipe bending machine is composing by:hydraulic bending pushing machine, bending Degree adjustment device, hydraulic pump, medium frequency heating system, operate panel, control panel of generators, panal of capacitors ,water cable, reactor. Cutomer shall purchase coils, pipe clamps according to machine sizes.
Your Demand,Our Liability TEL:0086-13931764957 E-mail:ceo@xnmac.com
Noticement on machine parts: 1. Idler wheel needs to be injected butter one time for each 5 days 2. Entrust wheel under front idler wheel case shall be inject butter one time for each 24 hours since it is near by heating coils. 3. Shift arm spindle shall be injected butter one time per year, running gear on rail, pipe wheel leading gear shall be injected oil one time for each 2 years since less speed of roll attrition. 4. Please clean up the seat of shift arm and inject butter to keep wet when adjusting bending radius, 5. Each active parts on flameout transformer and screwed poles shall be injected butter one time for each two days 6. Please check fastners of main machine each month and ensure that they are in a tighten situation all the way 7. Please return oil vat's piston pole to terminal to refuse hitting on piston pole if equipment is not use. 8. Please give a empty trial running after a long stop of equipment ,ensure that it is in a right working situation
