Carbon steel elbow machine

As we all know, hydraulic system is one of the most important part to hydraulic carbon steel elbow machine.Hydraulic system during working it has power lost, including pressure lost,volume lost and mechanical lost three aspects, all these lost turn into heat, make the hydraulic system oil temperature rising.Normally we control the temperature of oil between 30-60 degree, not exceed 60-70 degree.

Without key link,the hydraulic carbon steel elbow machine is of better power distribution. Driven by a double-cylinder , when the arm is near the settleed point of bending,the hydraulic system will buffer automatically, improving the precision of reset and the work efficiency.Full hydraulic drive, micro-controller can be preset of 16 angle,the use of foot switch will complete the whole process.

Tips fro hydraulic carbon steel elbow machine

1.Check each part of fasteners, ensure they are fixed.

2.Make sure that all connectors of the hydraulic pump station are equipped with oil seal rings, if the seal rings appear damaged or oil leakage, should be replace timely.

3.If found forward or backward abnormality, first check electro-hydraulic valve whether operate normal, if working normally, then you should check whether the electro-hydraulic relief valve or the one-way unloading valve has contaminant that made it could not working or not(this phenomenon usually happen when you just use this machine). If has contaminant, you should open it, clean by gasoline or diesl oil, everything is ok, then re-install.

4.Operated this equipment within 15 days, you should clean the tank and filter hydraulic oil once.

5.When cleaning tank, you should clean the inside the oil filter of tank also.