Elbow making machine

Hei Yan Elbow making machine is composed by: Hydraulic main pushing machine, hydraulic pump, operate panel, control panel of generators, medium frequency, compensating capacitor, water cable, induction coils adjust frame, reactor.

1.The supporting plate, pushing plate of the machine is formed by 20mm medium plate welding ,the center hole diameter is 350mm.
2. Pushing plate and supporting plate strobe of Elbow making machine are all used hydraulic control .
Note: In order to improve efficiency, the pushing plate strobe also was changed to the hydraulic control .
3.Anterior supporting plate is equipped with clip pipe fittings.
Please kindly contact with us for your interested elbow forming machine,pipe bending machine,pipe expanding machine,hydraulic press, hot induction heating power.

Maintenance of machine:

The equipment should be serviced about once a month, maintenance as following:

1.Check each part of fasteners, ensure they are fixed.

2.Make sure that all connectors of the hydraulic pump station are equipped with oil seal rings, if the seal rings appear damaged or oil leakage, should be replace timely.

3.If found forward or backward abnormality, first check electro-hydraulic valve whether operate normal, if working normally, then you should check whether the electro-hydraulic relief valve or the one-way unloading valve has contaminant that made it could not working or not(this phenomenon usually happen when you just use this machine). If has contaminant, you should open it, clean by gasoline or diesl oil, everything is ok, then re-install.

4.Operated this equipment within 15 days, you should clean the tank and filter hydraulic oil once.

5.When cleaning tank, you should clean the inside the oil filter of tank also.