Elbow pushing machine:

Hei Yan elbow pushing machine is composed by: Hydraulic main pushing machine, hydraulic pump, operate panel, control panel of generators, medium frequency, compensating capacitor, water cable, induction coils adjust frame, reactor.

Elbow pushing Machine working principle and operation procedure:

The Elbow Machine adopt Medium Frequency Power Supply to heat steel tube and push the tubing stablly. The heating part of the pipe running along the preset orbit to form bending radius and Angle of the elbow pipe. Firstly,we should install tubing in place, and then adjust the bending radius through the rocker arm nut screw transmission.we adopt Medium Frequency Induction Heating Coil to bend tubing in a certain temperature,the bending motive power is hydraulic press, the dolly will move steel pipe forward, During heating the  steel pipe,the tubing was deformed according to the correct bend radius.After its deformation,we should cool the elbow pipes in water and we can obtain pipe fittings we required.

If you are interested in our elbow pushing machine, do not hesitate to contact us. Hei Yan also supply,pipe bending machine,pipe expanding machine,cold draw tee machine,hydraulic press,medium frequency power supply,moulds and so on.

Maintenance of machine:

The equipment should be serviced about once a month, maintenance as following:

1.Check each part of fasteners, ensure they are fixed.

2.Make sure that all connectors of the hydraulic pump station are equipped with oil seal rings, if the seal rings appear damaged or oil leakage, should be replace timely.

3.If found forward or backward abnormality, first check electro-hydraulic valve whether operate normal, if working normally, then you should check whether the electro-hydraulic relief valve or the one-way unloading valve has contaminant that made it could not working or not(this phenomenon usually happen when you just use this machine). If has contaminant, you should open it, clean by gasoline or diesl oil, everything is ok, then re-install.

4.Operated this equipment within 15 days, you should clean the tank and filter hydraulic oil once.

5.When cleaning tank, you should clean the inside the oil filter of tank also