Hot induction elbow machine

Operation of the hot induction elbow machine

Operating procedures are as following:

According to the elbow size select the main pushing pump-- As per the elbow size select the speed -- feeding, close gate --After the mandril been heated to a suitable temperature begin pushing (during working the pushing speed is adjustable) -Reaching the end point ,pushing machine stop automatically- Strobe fix the core rod  -- feeding -- release the strobe, pushing machine return to the end point -- strobe leave the core rod 5mm starting pushing

Note:

1, Main pump can be used the same time when working, in general, using one.

2, Return pump can not be used the same time, only one start and one spare.

3, Feed pump can be used only when feeding .

4, Main cylinder ,make the safe pressure at 25Mpa,make the attached cylinder safe pressure at 10MPa.

5, The actual stroke should be less than the maximum stroke .Both sides of the pushing plate are away from the actual end-point 50-80mm, so as not to run to the tanks at both ends of cylinder piston , crash cylinder flange, resulting to equipment damage. (Trip switch should be replaced once every two months to ensure normal work.)

6, Attached cylinder adjustment is controlled by hand-directional valve and adjusted according to the elbow size.

More information of the Hot induction elbow machine,contact with us.

Maintenance of machine:

The equipment should be serviced about once a month, maintenance as following:

1.Check each part of fasteners, ensure they are fixed.

2.Make sure that all connectors of the hydraulic pump station are equipped with oil seal rings, if the seal rings appear damaged or oil leakage, should be replace timely.

3.If found forward or backward abnormality, first check electro-hydraulic valve whether operate normal, if working normally, then you should check whether the electro-hydraulic relief valve or the one-way unloading valve has contaminant that made it could not working or not(this phenomenon usually happen when you just use this machine). If has contaminant, you should open it, clean by gasoline or diesl oil, everything is ok, then re-install.

4.Operated this equipment within 15 days, you should clean the tank and filter hydraulic oil once.

5.When cleaning tank, you should clean the inside the oil filter of tank also.

E-mail:ceo@xnmac.com
Fax:0086-317-3017257
Website:www.xnmac.com 
        www.elbow-machine.com