Hot induction elbow machine is designed for the processing of elbow. We can produce diameter 21mm-1420mm, wall thickness 3mm-80mm, over 1D carbon steel, alloy steel elbow machine.
One is induction heating system, using 380V,50HZ three-phase alternating current, through thyristor to convert the frequency, to make 2500HZ medium frequency current, heating the raw material.
The other is hydraulic pushing system, this system can push the heated raw material to the mould end,then form elbows. The requirement to workshop and auxiliary of Hot induction elbow machine Each machine medium frequency cooling water should above 50m3 and has the dust prevention device. Normally require the workroom length 30-40 meters, single machine width 6-8 meters. Welcome to contact with us for elbow machine, we also manufacture,pipe expanding machine,pipe bending machine,medium frequency heating equipment according to customer requirement.
Your Demand,Our Liability TEL:0086-13931764957 E-mail:ceo@xnmac.com
1.Check each part of fasteners, ensure they are fixed.
2.Make sure that all connectors of the hydraulic pump station are equipped with oil seal rings, if the seal rings appear damaged or oil leakage, should be replace timely.
3.If found forward or backward abnormality, first check electro-hydraulic valve whether operate normal, if working normally, then you should check whether the electro-hydraulic relief valve or the one-way unloading valve has contaminant that made it could not working or not(this phenomenon usually happen when you just use this machine). If has contaminant, you should open it, clean by gasoline or diesl oil, everything is ok, then re-install.
4.Operated this equipment within 15 days, you should clean the tank and filter hydraulic oil once.
5.When cleaning tank, you should clean the inside the oil filter of tank also
