Accessories of the process
1. Intermediate frequency power source
2. Heating induction coil
3. Mandrels
4. Hydraulic press
5. Bevel machine

Characteristics Hydraulic induction heating elbow machine   

   Hydraulic controlled pushing pedal gate
   Hydraulic valve adopt Standard series, magnetic valve 24 control
   Supporting pipe is equipped
   Supporting plate, pushing plate,gate and gate slide way are under careful process
   Valve gate, pushing gate adopts 45 # steel plate
   Annealing treatment after welding of supporting plate and pushing plate etc.
   passivation and picking treatment after welding pump oil pump

Maintenance of machine:

The equipment should be serviced about once a month, maintenance as following:

1.Check each part of fasteners, ensure they are fixed.

2.Make sure that all connectors of the hydraulic pump station are equipped with oil seal rings, if the seal rings appear damaged or oil leakage, should be replace timely.

3.If found forward or backward abnormality, first check electro-hydraulic valve whether operate normal, if working normally, then you should check whether the electro-hydraulic relief valve or the one-way unloading valve has contaminant that made it could not working or not(this phenomenon usually happen when you just use this machine). If has contaminant, you should open it, clean by gasoline or diesl oil, everything is ok, then re-install.

4.Operated this equipment within 15 days, you should clean the tank and filter hydraulic oil once.

5.When cleaning tank, you should clean the inside the oil filter of tank also.