OD325mm hot elbow pushing machine

Technical data of the OD325mm hot elbow pushing machine:
 
1. Main Cylinder: Inside OD 220mm,Outside OD273mm,Stroke 4 meters.Two cylinders.Total pushing force:200 tons.

OD325mm hot elbow pushing machine Features Description
1. The supporting plate, pushing plate of the machine is formed by 20mm medium plate welding ,the center hole diameter is 350mm.
2. Pushing plate and supporting plate strobe all used hydraulic control .
Note: In order to improve efficiency, the pushing plate strobe also was changed to the hydraulic control .
3. The main hydraulic valve parts adopt international standards Rexroth Products (Beijing Hua De), solenoid valves are controlled by DC 24V .
4. Anterior supporting plate is equipped with clip pipe fittings.
5. Each side of Support plate, pushing plate, gate, gate slide are all processed with planer milling
6. Supporting plate gate and pushing plate gate all used 45 # steel plate.

Hei Yan also manufacture pipe expanding machine,pipe bending machine,hydraulic press,tee machine,hot induction heating equipment.

Note:The actual stroke should be less than the Max stroke,which means it will be 30~50mm space left for front and rear,to avoid the cylinder strike the cylidner flange,result damage to the equipment.
The equipment should be installed according to the foundation drawing the manufacturer offered,the equipment shoud be placed flat.Before shipment, the eqipment will be tested to fine condition.After water and electricity Ok,manufacturer will install and debug.

Requirement of the workshop
1Pump station and induction heating power source had better be placed in the sub room of the workshop
2The cooling water pond should be bigger than 50 cubic meters and equipped with anti-dust measures.
3 The length of workshop had better longer than 45-60meters,wideth should be 8-12 meters.