Correct hydraulic press

The Correct hydraulic press machine can be used to correct the ends of the steel pipe and pipe fittings, with the many years experiences, we can also do according to customer's require.
Main Application and features of the Correct hydraulic press:
1. The machine is mainly used for shaft and sleeve parts to correct, press and repression of small powder products ,it can also be used for other similar processes, structures with C-type machines installed in the fuselage .The Hydraulic press has neat and tidy appearance, it has a button or foot pedal two mode operations.
2. Working pressure of the hydraulic press and stroke can be adjusted within the specified scope.
3. The hydraulic press can be equipped with electric hoist, cantilever device.
4. This machine has an independent power sector and electrical systems, it can achieve manually and semi-automatic operate modes.

Hydraulic press safe operating attention
 
1. Before starting, check parts of press manipulation, clutch and brakes are active, the security guard is complete and easy to use, whether ministries crank exception. If abnormal, should immediately take the necessary measures
2. Before formal operating subject to idle test, be sure each part can normal work.
3. The operation must use the tools, is prohibited by hand directly into his mouth extract die, hand tool should not be putted on the mold.
4. Foot must be far away from the foot pedals, when adjust or get the workpiece in mould area.
5. Sudden power off or operate finished, we should close the power, and restored to the clutch in neutral gear manipulator, brake in braking.
6. On the press for maintenance, adjustment and installation, adjustment, dismantling the mold should be disconnected the machine energy (such as electricity, gas, liquid). Putting warning notice on the startup switches.